1. Test pressure: 80MPa, pressure display to 0.1MPa-

2. Pulse frequency: 0.5-1.25Hz

3. Vibration frequency: 10-50Hz

4. Flexural frequency: 0.5-1.0Hz

5. Test medium: hydraulic oil or brake fluid

6. Oil temperature: ambient temperature～150±3℃

7. Cycle times: > 10 million times

8. Number of samples: 2-8 (depending on the total volume and physical properties of the sample)

9 Test waveforms: square wave, trapezoidal wave, triangle wave, sine wave

10. Installation angle: 90 degrees or 180 degrees

11. Interface spacing: >90mm

12. Control mode: industrial computer

13. Power system cooling method: water cooling

14. Dimensions: about 2350×1600×1850mm

Main functions and features:

1. It is composed of computer and American NI acquisition card (LABVIEW software) control system. It adopts electro-hydraulic servo control. The pulse pressure can be adjusted arbitrarily within the adjustment range, and the control is high.

2. Multi-channel and multi-station, multi-channel tests can be carried out at the same time without affecting each other. When the tested workpiece is blasted during the pulse test, it will not affect other workpieces to continue testing, realizing unattended, automatic recording and saving of experimental data and graphics in the computer.

3. Use computer for data collection, control and management. Pulse pressure, ambient temperature, medium temperature, number of tests, and waveform can all be set through the human-machine interface, and can be printed out.

4. The accumulator is used to supplement the pressure to improve the reliability, stability and service life of the pressurized system, while ensuring the pressure accuracy.

5. At the beginning of the test, the gas in the sample is automatically removed (for the hose test), the number of test pulses is reached, the machine is automatically shut down, and the leaked medium after dismantling the tested workpiece is automatically recovered.

6 The inner layer of the observation window is a protective net, and the outer layer is plexiglass to ensure personal safety to the maximum extent. Built-in lighting, easy to assemble and disassemble workpieces and observe internal test conditions when the light is poor